"Reopening" open area

Discussion in 'Apex' started by goingvirtual, Oct 25, 2010.

Thread Status:
Not open for further replies.
  1. goingvirtual

    goingvirtual New Member

    0
    Apr 13, 2008
    Professional Status:
    Certified Residential Appraiser
    State:
    New Jersey
    I was about 3/4 of the through entering the second floor of a complicated SF dwelling when I had to go out for an appointment. Rather than just closing out the area, I saved it and exited the program. Now I'm trying to continue on, but both of the "reopen" functions only pertain to closed areas, and "selecting the area" doesn't work either. Is there a way to continue with what I was doing or do I need to delete the open area and start over?

    BTW, I'm using Apex Medina V4 Appraiser.

    Thanks,
    Mike
     
    Last edited: Oct 25, 2010
  2. Randall Garrett

    Randall Garrett Senior Member

    1
    Mar 6, 2004
    Professional Status:
    IT Professional-Appraisal Related
    State:
    Texas
    Mike,

    There used to be a "Resume Area" which was taken out at some point since nobody seemed to use it, but as usual, I left the function in the program, so not it is sort of a "secret Power User" thing...

    Open the sketch, then hit [F5] twice and you should resume where you left off...

    Think I'll put the Resume Area thing back on the menu again... ;-) Making note of this for the next update, due before the end of the year. As a registered v4 user, you will get the update for free... :)

    Hope this helps!

    -Randall Garrett-
    ..Apex Software..
     
  3. goingvirtual

    goingvirtual New Member

    0
    Apr 13, 2008
    Professional Status:
    Certified Residential Appraiser
    State:
    New Jersey
    Thanks, Randall. That worked.
     
Thread Status:
Not open for further replies.

Share This Page