[Lanny A Freng]

Anyone know if it is possible to adjust the grid to increments of 1 like you can on the desk top instead of the zillion it is broken down into. Just about impossible to put the cursor where you want it with your finger. Says you should be able to move the cursur after you hit the screen with your finger via the arrows but I have yet to get that to work. Any ideas?

[Tom Woolford]

Originally Posted by Lanny A Freng

Anyone know if it is possible to adjust the grid to increments of 1 like you can on the desk top instead of the zillion it is broken down into. Just about impossible to put the cursor where you want it with your finger. Says you should be able to move the cursur after you hit the screen with your finger via the arrows but I have yet to get that to work. Any ideas?

Just like on and iPad or smart phone, use two fingers to "pinch" or spread the screen to change scale. Doesn't matter where you put the cursor, its a simple matter to move it. If you are trying to hit a previously set point, just spread to zoom in, place the cursor, then pinch to zoom out.

[Lanny A Freng]

been trying to do it as you said too, works fine if you have a red dot to hit but if you are trying to drop a point for a deck mid exterior wall it is a PITA to get it right on the grid line even zoomed in all the way. Pull your finger off the screen and it moves it just about everytime. If you start off sketching the deck just a bit off it screws up the rest of it and you end up having to go into the sketch on the desk top to adjust it so you have even numbers and everything is square. Seems like a real simple funtion to add in grid increments you can choose (.1, .5, 1 etc). Maybe for Christmas it will get worked in....

[Lanny A Freng]

another question regarding the garage. It is not automatically transfering the garage square footage from the sketch to the cost approach section like it does when you sketch on the desktop. Any one else have this issue and is there a setting to change so it does?

[seth84]

If you're going to do your inspections with an iPad then you may want to consider using a program like logmein to control your desktop from your iPad and just do the sketch on your computer. I think it's easier to just do the inspection with a regular clipboard though.