Eliminating Text in Medina V4

[Elliott]

Is there a easy way to remove a goof text on a diagram??

I've play around for 30 minutes, read the manual, and I just
don't get it. Doesn't seem to be a 'edit' text so you can clear it.
Sure you can change font, but that's it.

 

[CGgonnabee]

Place cursor over the text and click...you should see four red squares on each corner of the text and a little blue triangle in the center, leave the cursor on the blue triangle. Press the delete key and confirm that you want to delete. This should make the text disappear.

 

[Elliott]

CG,
Thanks, I've discovered it works 'sometimes.' I think it only
works that way when in the AREA mode. One small step.

 

[Atlanta CG]

You have to be out of the "free form" line part. If you click and the 4 squares do not appear, go back to "free form" lines, click that again and then the 4 corners will work.

 

[Elliott]

John,
Thanks. I'm sure that's it.

 

[Elliott]

When all else fails, I've found if I save the report, exit out, return to Apex,
then I can click on the text and delete it. Its not as easy, but a reliable method.

 

[Randall Garrett]

Before you try switching "modes", exiting or any of that stuff, try hitting [F10] to refresh the screen and see if that helps...

Hope this helps!

-Randall Garrett-