From what I understand of this post, the lender asked for market value of an REO property, usually that means a 1004 with an REO addendum
and then a BPO was done which came in lower, and the client asked the appraiser if they could change their value to "meet in the middle" with the BPO value...this request of the client is not appropriate, the client is now directing the value and telling the appraiser what value they want, which as you know we are not supposed to appraise to a predtermined value.

[/B]
I am not sure what you mean by this...I suppose you mean the OP should verify with the lender what kind of value they are looking for. IF they tell the OP they want a value other than market value, then the OP better disclose that on the report. From what I understand of this post, the lender asked for market value of an REO property, usually that means a 1004 with an REO addendum, and then a BPO was done which came in lower, and the client asked the appraiser if they could change their value to "meet in the middle" with the BPO value...this request of the client is not appropriate, the client is now directing the value and telling the appraiser what value they want, which as you know we are not supposed to appraise to a predtermined value.
IF the OP reads the BPO and finds there were better comps used and wants to put new comps in and make a new value, that should be up to the appraiser, and not at the direction of the client.
I have often been handed BPO's to comment on, some are lower than my values and some higher. So what, that is their opinion of value, I made mine. I rarely if ever found the BPO value that differed substantially from mine was well supported, but that is my experience with them.
This is where I have to agree with Resguy. The SOW is not clearly defined. Even in your comment highlighted in red it is not clearly defined. You used the phrase "usually that means a 1004 with an REO addendum". I would say that on 99% of the REOs that I have done the lender has specificly asked for the REO addendum. I have contacted the lender to see if they wanted the REO addendum if it was not requested in the letter of engagement.
I would say that a lot of lenders/clients don't know what they want or need when ordering an appraisal. The only form they are familiar with ith the 1004 URAR and they think that is what is supposed to be used. They don't realize that there are other forms that should be used when ordering a REO appraisal. The GP form would be a good start. We cannot assume that the lender/client wants MV just because they ordered a 1004 URAR. You know what happens when you assume something don't you?
I would say that a lot of lenders/clients don't know what they want or need when ordering an appraisal. The only form they are familiar with ith the 1004 URAR and they think that is what is supposed to be used. They don't realize that there are other forms that should be used when ordering a REO appraisal.
I disagree, lenders are very familiar with report requirements and value types. The specific forms and type of values ordered are decided by bank policy and following federal regs as well as from input by the chief appraiser at the bank...individual loan officers don't get to "decide" what kind of value they want. These lenders know it is market value when they assign on a 1004 form, and if they want an REO addendum attached, they know why they want that as well.
I think the confusion is among appraisers, they think that providing an opinion of market value means using the highest price non REO sales as a bench mark....this has been argued many times on the board, so won't repeat it here...:mellow:
Do you guys live in LALA land??? It is not about us ASSUMING what a lender wants, it is about us giving an opinion of value consistent with what is on the form ( or what we write as the purpose of appraisal if it is a narrative).
Therefore if an REO addendum was not requested in SOW and was not done then the value should NOT be any sort of "REO value".
YOUR clients may be expecting an attached REO addendum, or it may be standard in your area, but if it is not in the SOW and it was not made clear before the SOW was agreed upon that it was to be required then the appraiser is correct in not developing it unless he feels it is necessary to produce a competent report.
I would say that it is common enough that I ask as soon as I realize the subject may be an REO so that SOW is clear between me and my clients, but that does not make it "usually" by a long shot. There are reasons to want both the FIRREA and other market values.
I would say that a lot of lenders/clients don't know what they want or need when ordering an appraisal. The only form they are familiar with ith the 1004 URAR and they think that is what is supposed to be used. They don't realize that there are other forms that should be used when ordering a REO appraisal.
I disagree, lenders are very familiar with report requirements and value types. The specific forms and type of values ordered are decided by bank policy and following federal regs as well as from input by the chief appraiser at the bank...individual loan officers don't get to "decide" what kind of value they want. These lenders know it is market value when they assign on a 1004 form, and if they want an REO addendum attached, they know why they want that as well.
I think the confusion is among appraisers, they think that providing an opinion of market value means using the highest price non REO sales as a bench mark....this has been argued many times on the board, so won't repeat it here...:mellow:
I guess we have to agree to disagree. Because, I don't believe they know what they want or need. They way want one thing but they need something else. IMO I don't believe that the 1004 URAR should be used for an REO appraisal per the intended use stated in the form itself.