• Welcome to AppraisersForum.com, the premier online  community for the discussion of real estate appraisal. Register a free account to be able to post and unlock additional forums and features.

Forum Sponsor - a la mode

QuickSource provides a single-source solution to easily import, compare, and manage data from multiple, credible sources in every report. See what the next game-changer is really all about.

Need Help Apex Printing Off Center

Not open for further replies.

David Mullen

Junior Member
Jan 17, 2002
I just got Apex 2 running with Toolbox under XP today using the integrator and it is not bad but when I print the sketch, it prints (and previews on the screen) about a half inch to the right. the grid runs to the right edge of the paper instead of stopping in the window provided by Bradford.

Has anyone else had this problem? I will call Bradford tech support Monday unless someone knows the solution. Thanks

Jo Ann Meyer Stratton

Elite Member
Jan 16, 2002
Professional Status
Certified Residential Appraiser
I had that problem for years with Day One because of the way I had my computer set up. I was using a 15" monitor, have bad eyesight, so had the computer set to large fonts. Would have to reset to small fonts, print my package, reset to large fonts so I could continue working. Finally bought a 19" monitor--have computer set to small fonts at all times and my problem has been solved.

David Mullen

Junior Member
Jan 17, 2002
Jo Ann

Thanks for responding.

This is an odd problem. Everything is working well in Toolbox and Apex until I print the sketch under Apex, Version 9.86, and Windows XP.

If I do the sketch with the old Apex in my Windows 98 partition, the sketch prints fine.

If I import a sketch drawn under Windows 98 and Apex IV into my Toolbox running under XP (I have a dual boot system), the sketch will print the way it should. However, if I alter that same sketch using Apex 2 in my XP partition, it will suddenly extend the grid out into the margin. The floor plan looks OK and seems to be in the right place but the grid looks odd hanging out there in the right margin.

I'm hoping for some setting that can be applied through the integrator or in Apex but may have to wait for tech support tomorrow. Fortunately, I did not delete my Windows 98 partition so I can keep doing sketches there for the time being.

Thanks again for taking the time to repond.

Not open for further replies.
Find a Real Estate Appraiser - Enter Zip Code

Copyright © 2000-, AppraisersForum.com, All Rights Reserved
AppraisersForum.com is proudly hosted by the folks at

AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock
No Thanks