- Joined
- Jan 15, 2002
- Professional Status
- Certified General Appraiser
- State
- California
CA often returns value indicators in excess of the SC. Not always, though.
The only reason the cost approach would not be close or in the ballpark of the sales comparison approach is because depreciation is not taken into consideration
There were instances where it appeared that the builder was making massive entrepreneurial profit, and that certainly wasn't rolled into the building cost data. You would figure an efficient market would not allow that by bidding up the site value, but apparently some builders are more clever than our inefficient market.
I wish as you state above, a big gap between value indicators and particularly between CA and SCA, appraisers did not try to close it by adding more EI or depreciation to make the approaches more similar . Allowing the gap to speak of the market would clearly show an imbalance to users/clients.Good point. Most of my appraisals have different value indicators from the different approaches to value. Sometimes by a little and sometimes by a lot.
I've told my clients on several occasions that based on the disconnect between the CA and the SC the proposed project was not financially feasible. Those borrowers sometimes go to a different lender and get the deal done anyway. Happens.
I've been an NC Appraiser for many years. Never heard a word about any nonsense like this. In one sense, it doesn't matter. The Client had provded a requirement that the Cost Approach be completed and the Appraiser accepted the assignment. Therefore, the Appraiser was obligated to complete the Cost Approach. He/She could then choose to give it a lot, some, or no weight during final reconciliation.New construction assignment in North Carolina. Client requires the cost approach on every SFR. This review on my desk comes with a minimum land value, and a blank C.A. In the comments on the cost approach section is the following remark:
"The Cost Approach was not developed due to the recommendation to the appraiser by members of the North Carolina Appraisal Board. The members of the appraisal board informed the appraiser that the Cost
Approach is considered unreliable. The appraiser was strongly encouraged not to attempt to calculate the Cost Approach to value."
The story I got from the appraiser, was that he had been in C.E and a member of the board was in class and made a declaration. This was supposedly not an official statement from the N.C. Appraisal Board.
Has anyone else run into this, or do this? I'd like to gather some local knowledge. Thanks everyone.
Contractor margins tend to be more stable than developer margins, but both run higher when the market is hot and run a lot cooler when the markets run cold.
The thing to bear in mind about the cost format Fannie uses in the URAR is that it's a bit abbreviated and it aggregates costs that are broken out separately in other cost formats such as are used for narratives or the commercial forms or even the 71a/71b apartment forms. For example, outside of 1-4 appraising we normally break out the indirects and developer profit elements separately from the hard costs. Depending on the database we're using we also apply location multipliers or make adjustments to account for the current market conditions when compared to the last time the costs were updated.
It's not the 5-second process that many appraisers use.