• Welcome to AppraisersForum.com, the premier online  community for the discussion of real estate appraisal. Register a free account to be able to post and unlock additional forums and features.

FNMA bedroom definition

Status
Not open for further replies.
My bad. 99.9% of us who have been employing ANSI since 1994 measure to 1/10 of a foot because it is much easier. Only the people throwing a fit about it prefer to measure to the inch, so they have grist for their grievance mill.
Except those that have a construction background. Where you measure to the inch.
 
Except those that have a construction background. Where you measure to the inch.
Okay. You do lots of reviews, how many sketches expressed in those measurements do you run across? I do plenty as well, and haven't run across a single instance unless someone had simply scanned the plan in.
 
Your E & O provider. And we measure to 1/10th of a foot, not to the inch.
ANSI provides that you maeasure to the inch.... OR... the 1/10th of a foot. Appraiser's choice. Both ways are compliant.
 
its about control
It may be about control to some degree... Although, many have measured to 1/10th of a foot from long before ANSI was mandated. The main point, for me, is no conversions when you whip out the calculator to figure area.
 
At the end of the day....
Unless the appraiser is going to make an adjustment for bedroom differences it really has no impact on the appraised value....
Other than the basement example but that's an entirely different can of worms...
 
Okay. You do lots of reviews, how many sketches expressed in those measurements do you run across? I do plenty as well, and haven't run across a single instance unless someone had simply scanned the plan in.
I very seldom dissect the sketch to that extent. To be honest. Most sketches I have seen are to the foot. Just about everybody in construction uses inches. Sorry I decided to stick with what I used for years prior to becoming an appraiser. If 1/10 of a foot is what you seem to consider an industry "standard". Why does ANSI give the option?
 
I very seldom dissect the sketch to that extent. To be honest. Most sketches I have seen are to the foot. Just about everybody in construction uses inches. Sorry I decided to stick with what I used for years prior to becoming an appraiser. If 1/10 of a foot is what you seem to consider an industry "standard". Why does ANSI give the option?
Because they didn't listen to me.
 
Status
Not open for further replies.
Find a Real Estate Appraiser - Enter Zip Code

Copyright © 2000-, AppraisersForum.com, All Rights Reserved
AppraisersForum.com is proudly hosted by the folks at
AppraiserSites.com
Back
Top